Forward Control Design Glock™ Gen6 ORS Acro® Mount Plate

Aimpoint®
Item
ME_300064


$95.00

  • For mounting ACRO sights on optic ready Glock ORS handguns
  • Compatible with Gen 6 Glock models
  • 17-4 stainless steel, black nitride finish
  • P-2 needs 0.385" or taller front sight for co-witness
  • Installation by certified gunsmith is recommended
Adding to cart… The item has been added

  Government Export Restriction: This item may be regulated for export by the U.S. Department of State or the U.S. Department of Commerce. Please see our Export Policy.


WARNING for California customers

Product Details


The Forward Controls Design ORS Acro® Plate is a heavy-duty optic plate that mounts an Aimpoint® Acro P-2™ to select Glock® Gen6 ORS pistols. The plate is milled from 17-4 stainless steel under a black nitride finish, with a rear relief design so the plate is held against movement along the bore, side to side, and rotation. 

Gen6 slides use larger screws with deeper countersinks than Gen5, so this plate mounts the ACRO slightly above the top of the slide. With an Acro P-2 installed, backup iron sights need a front sight height of at least 0.385 inches, which provides a lower 1/4 co-witness. The plate fits most Gen6 duty holsters, but fitment may be an issue if a TangoDown P-2 Lens Guard is installed. T20 M4 0.7 x 8mm plate screws and a packet of VC-3 thread locker are included. Made in the USA. 



FAQ Material
- Small gap at the front of the plate: a 0.001-0.002" gap may appear depending on slide tolerances. It is cosmetic, can occur with any Gen 6 plate, and removing it can change elevation.
- Visible tool marks: fine tool marks inside the lightening cuts are micron-level, more visible after black nitride, and hidden once installed.